What is a solder mask? Solder mask is the thin polymer layer that is applied to a printed circuit board to insulate copper traces from un...
What is a ground plane? A ground plane is a large area of copper in a printed circuit board design that is connected to ground on the pow...
How do I manually route a design in PCB Editor? Your design should have a board outline and components placed, and blue lines (the "...
What is a board outline? A board outline is the outermost boundary of a printed circuit board design. It is used by the PCB manufacturer t...
What is a printed circuit board (PCB)? See the What is a Printed Circuit Board? page for more information about PCBs and the general des...
Why would I need to change the library search path? When creating a custom PCB footprint for a component, it is stored somewhere on your c...
Why would I need to change the library search path? When creating a custom PCB footprint for a component, it is stored somewhere on your c...
Popular Posts
-
Before using Cadence, configure it for optimal performance by following the instructions below. Step 1. Create a Cadence Folder Hierarchy ... -
How do I manually route a design in PCB Editor? Your design should have a board outline and components placed, and blue lines (the "... -
Introduction When drawing a circuit, you will often move and delete components as part of the process, meaning that the reference designat... -
What is a board outline? A board outline is the outermost boundary of a printed circuit board design. It is used by the PCB manufacturer t... -
Introduction When drawing a schematic, crossing wires can make the schematic difficult to read and follow signals (see example, Figure 1).... -
You can use VCC (power) and GND (ground) symbols to connect power and ground instead of manually routing wires across your schematic. This... -
How do I measure the spacing between pins to make sure my footprint matches the Datasheet? See the How to check your footprints using the Or... -
Why would I need to change the library search path? When creating a custom PCB footprint for a component, it is stored somewhere on your c... -
Introduction A PCB footprint is the physical layout on a PCB to which a component is soldered. Usually, you must create a custom PCB fo... -
Introduction A padstack is a design for the exposed copper surface area for each hole or pad on the board where the component is mounte...